Case 3

Good Practices

Dampness

Design

The material selection for exposed surfaces, and their regularity and surface texture should be detailed to
prevent moisture retention. Areas prone to high moisture exposure shall be made impervious with adequate waterproofing systems. Also such surfaces should be without impediments (e.g. built-in cabinet, fixed equipment/services) to ensure access for inspection and to ensure ease of cleaning. Access for adequate cleaning should be provided in accordance with BS 8221- 1, SS 509-1 or equivalent. Ventilate to prevent moisture retention on floor/wall/ceiling. For natural ventilation, opening > 5% of floor area. For mechanical ventilation, air exchange rate > 20 air changes per hour, in accordance
with “CP on Environmental Health”.

Construction

Exterior surfaces of porous building material (e.g., cellulose, brick, stone, cement rendering) can develop biological growth. Avoid such growth as much as possible with treatments of anti-algae/anti-fungus solutions and allow to dry before painting/repainting (SS 652: B.5.2.1). Improve ventilation and remove sources of dampness to dry out the substrates as thoroughly as possible during painting works in
accordance with BS 6150, SS 542 or equivalent. Ensure a

Painting

Anti-fungus paint according to SS 345 can also be used on the walls.

Water repellent and surface coating system

Clear water repellents are most effective at reducing the amount of water absorbed by the brick masonry. Thus, they can help reduce staining and fungi growth caused by moisture absorption, particularly on highly absorptive masonry.

Surface preparation is important. The surface on which the coating is to be applied has to be:

• cleaned by grinding, chemical etching or blasting.
• dried by allowing the wall to cure for a few days before the coating is applied. During rainy periods, the walls should be protected with a plastic covering so that the drying is not interrupted.

Other surface protection systems include:

• Impregnation systems:
  • Prevent penetration of water and solutions into brick without hindering the escape of internal moisture from concrete
• Materials used [3]:
  • silicon organic solutions
  • resins
  • oils
• Sealers
  • Heavy barrier against penetrating solutions but may hinder the escape of internal moisture
• Materials used [3]:
  • epoxy resins (EP)
  • polyurethane resins (PU)
  • unsaturated polyester resins (UP)
• Coatings
  • compared to sealers, they provide additional protection against mechanical influence.
  • increased resistance to diffusion of internal moisture
• Materials used [3]:
  • plastic modified cement systems and resins